Guide showing how to set modes in cleanflight and betaflight and map these to switches or buttons on your Taranis. Add in switches
I'll teach you how to set up flight modes in betaflight and cleanflight. You can use a switch to activate Angle Mode, Horizon Mode, Air
Demo showing advanced new switch configuration functionality in Cleanflight.
Here's a how-to explaining and demonstrating how to setup in-flight adjustments such as PID tuning in Cleanflight. I am using a
Thanks too TomPeer for the .ini setup help. How to mix 4 flight modes into a single AUX channel on cleanflight using one 3-way and
today i describe how i arm via aux channel without completely losing control if i accidentally touch the throttle stick to the "0" position
Now that we have added a receiver to our multirotor it's time to create switches in the FrSky Taranis Q X7 and set them up in
Moving along with the FrSky Taranis X9D Plus series, its now time to create switches in the Taranis then set them up in Betaflight or
Its not so much the video its more of the trying to tell you how to make your motors spool up when you arm it on a arming switch.
Hope this helps someone, its only a quick guide/explanation. I've just re-done all my switches and mixers so I have 3 flight modes,
Cleanflight (NAZE32) Disarm and Arm with Transmitter Switch Tutorialby Johnathan Smith This video is going to show you how to
You can adjust your PIDs, rates, and other parameters IN FLIGHT using your transmitter switches and Aux channels. This feature is
Taranis X7 w. OpenTX Tutorial - First Flight Setup Using FrSky Installed OpenTX http://rcdiy.ca/taranis-q-x7-tutorial-first-flight-setup/
Configuring the BeeRotor FC with CleanFlight and configured built-in OSD for three flight modes, ACRO, Stabilize and Horizon
If your looking to enable your transmitter so you can change PID's while your tuning your quad, this is the tutorial for you. In this
Here are a couple of issues with cleanflight, when pid_controller is set to 2. The first one is that if your rates aren't very high, then
This is a short video on how to change your channel mapping in CleanFlight i.e. if you find that when you put the throttle stick up on
Testing the ANGLE, BARO and MAG modes on my Flip32+ flight controller using Cleanflight...i just changed from a KK2.1.5 to this
2015 © All Rights Reserved.